So you want to know how to set up your own kitchen under cabinet lighting rail molding. Do not attempt the particular installation unless you possess some basic carpentry skills. You will also need a few strength and hand tools. Do not try this phase of your kitchen cabinet set up without having sufficient time. NO hands miter box cutting allowed! You have to achieve the highest quality install possible.
Tools and Materials Needed:
- Chop Saw
- Electric Drill
- Three Clamps (I prefer Jorgensen Clamps)
- Correct Duration Screws
- Countersink Bit
- 1/16" Initial Hole Drill Bit
- 3/16" Drill down Bit
- Hand Screw-driver
- Yellow Carpenters Glue
- Matching Wood Putty Stick
One of the most popular questions people request is; "should the molding become installed flush or recessed with all the face of the cupboard? " I usually recess the light rail no less than one particular eight (1/8") of an inch. This particular just looks better than trying to get this perfectly flush with the face-frame. Remember that the light rail should be flush with all the end of the cabinet next to in which a space-saver microwave gets installed.
Roughly measure the length of each piece of creating you will need and add four in . to each piece. Hopefully a person thought to order plenty of extra in the event you make a mistake. Cut all of the pieces you require over size first.
Now reduce a few "small" practice miter parts at forty five degrees. These ought to be used to double check that your corners in the cupboards are at true ninety level angles.
Now, when you start cutting the exact molding pieces of light rail, just cut the angles on one item at a time. The key to installing the particular molding correctly is in working out the particular accurate details one piece at the same time and one miter joint at a time.
Prior to making your cuts, drill openings from the inside of the cupboard downward utilizing the three sixteenths inch (3/16") drill down bit. Then, counter sink the particular holes from inside the cupboards. These are the particular holes that will secure the creating to the cabinetry.
The finished finish pieces of molding will be attached to the particular cabinets with ¾" x 1" X 8-1/2" blocks. The prevents get fastened to the short come back pieces of molding and then screwed towards the cupboard from underneath. The reason for performing it this way is because you cannot fasten all of them from the inside of the cabinet.
Installing Kitchen cabinets Light Rail:
- Decide which item is best to install first (consider functioning largest to smallest)
- Make your own cuts
- Apply yellow glue moderately to the miter joints
- Clamp the particular piece in place using the Jorgensen clamps
- Drill the light rail through the counter-top sunk holes using the 1/16" drill down bit
- Secure the molding in position with screws
- Wipe off the entry glue immediately with a damp cloth
- Repeat these steps on each lighting rail piece
The three sixteenths in . hole you drilled should be larger than the screws you are installing the particular molding with. If you need to adjust the particular molding a little, loosen the anchoring screws with a hand screw-driver. Align the sunshine rail accordingly and then secure this tightly into perfect position.
If you begin to get frustrated, take a break. This really is tedious work. The joints in the kitchen cabinet light rail should be since tight as possible.
The final action of the installation process is filling up the miter joints with the complementing wood putty. Wipe off any kind of excess putty with a dry cloth. (**
Comments
Post a Comment